CONFigure Subsystem (WLAN, K91 / K91n) R&S FSL
1300.2519.12 6.700 E-11
CONFigure:BURSt:EVM:ECARrier[:IMMediate]
This remote control command configures the measurement type to be EVM vs Carrier. After this
command has been executed, the specified measurement will only be started when the user
issues the INITiate[:IMMediate] command.
Example
CONF:BURS:EVM:ECAR
Configures the EVM vs Carrier measurement type.
Characteristics
*RST value: –
SCPI: device–specific
Mode
WLAN
CONFigure:BURSt:EVM:ESYMbol[:IMMediate]
This remote control command configures the measurement type to be EVM vs Symbol. After
this command has been executed, the specified measurement will only be started when the
user issues the INITiate[:IMMediate] command.
Example
CONF:BURS:EVM:ESYM
Configures the EVM vs Symbol measurement type.
Characteristics
*RST value: –
SCPI: device–specific
Mode
WLAN
CONFigure:BURSt:PREamble[:IMMediate]
This remote control command configures the measurement type to be Phase or Frequency vs
Preamble. After this command has been executed, the specified measurement will only be
started when the user issues the INITiate[:IMMediate] command.
Example
CONF:BURS:PRE
Configures the preamble measurement type.
Characteristics
*RST value: –
SCPI: device–specific
Mode
WLAN
To Next Page
Loading...
