R&S FSL CONFigure Subsystem (WLAN, K91 / K91n)
1300.2519.12 6.699 E-11
E
xample
C
ONF:BURS:CONS:CARR:SEL –26
Carrier –26 is selected.
CONF:BURS:CONS:CARR:SEL 10
Carrier 10 is selected.
CONF:BURS:CONS:CARR:SEL ALL
A
ll carriers are selected.
CONF:BURS:CONS:CARR:SEL PIL
Pilots only.
Characteristics
*RST value: ALL
SCPI: device–specific
Mode
WLAN
CONFigure:BURSt:CONSt:CCARrier[:IMMediate]
This remote control command configures the measurement type to be Constellation vs Carrier.
After this command has been executed, the specified measurement will only be started when
the user issues the INITiate[:IMMediate] command.
Example
CONF:BURS:CONS:CCAR
Configures the Constellation versus Carrier measurement type.
Characteristics
*RST value: –
SCPI: device–specific
Mode
WLAN
CONFigure:BURSt:CONSt:CSYMbol[:IMMediate]
This remote control command configures the measurement type to be Constellation vs Symbol.
After this command has been executed, the specified measurement will only be started when
the user issues the INITiate[:IMMediate] command
Example
CONF:BURS:CONS:CSYM
Configures the Constellation versus Symbol measurement type.
Characteristics
*RST value: –
SCPI: device–specific
Mode
WLAN
To Next Page
Loading...
