Rohde & Schwarz R&S FSL3 - Page 1466

R&S FSL CONFigure Subsystem (WLAN, K91 / K91n)
1300.2519.12 6.707 E-11
CONFigure:STANdard
This remote control command specifies which Wireless LAN standard the option is configured to
measure.
Parameter
0 IEEE 802.11a
1 IEEE 802.11b
2 IEEE 802.11j (10 MHz)
3 IEEE 802.11j (20 MHz)
4 IEEE 802.11g
5 Turbo
6 IEEE 802.11n
Example
CONF:STAN 0
Selects the IEEE 802.11a standard for the measurement.
Characteristics
*RST value: 0
SCPI: device–specific
Mode
WLAN
CONFigure:WLAN:GTIMe:AUTO
This remote control command specifies wether the guard time of the IEEE 802.11n input signal
is automatically detected or specified manually.
Example
CCONF:WLAN:GTIM:AUTO ON
Sets automatic detection of the guard time of the input signal
Characteristics
*RST value: --
SCPI: device-specific
Mode
WLAN