CONFigure Subsystem (WLAN, K91 / K91n) R&S FSL
1300.2519.12 6.708 E-11
C
ONFigure:WLAN:GTIMe:SELect
This remote control command specifies the guard time of the IEEE 802.11n input signal. If the
guard time is specified to be detected from the input signal using the
CONFigure:WLAN:GTIMe:AUTO command then this command is query only and allows the
detected guard time to be obtained.
Example
CCONF:WLAN:GTIM:SEL SHOR
Configures signal measurements with short guard times
Characteristics
*RST value: --
SCPI: device-specific
Mode
WLAN
To Next Page
Loading...
