Rohde & Schwarz R&S FSL3 - Page 1294

R&S FSL DISPlay Subsystem (Noise Figure, K30)
1300.2519.12 6.535 E-11
D
ISPlay:CURRent:DATA[:STATe]
This command switches the display of the current measurement results on or off.
This command is available from firmware version 1.60.
Parameter
ON | OFF
Example
DISP:CURR:DATA OFF
Removes the current result traces from display.
Characteristics
RST value: ON
SCPI: device–specific
Mode
NF
DISPlay:DATA:TRACe<1>
This command specifies the type of noise results to be displayed in trace 1.
Only the numeric suffix <1> for noise results is valid.
Parameter
NFIGure noise figure results in dB
TEFFective noise temperature in K
Example
DISP:DATA:TRAC1 NFIG
Displays the noise figure results in trace 1.
Characteristics
*RST value: NFIGure
SCPI: device–specific
Mode
NF
DISPlay:FORMat
This command activates or deactivates the combined trace display of noise and gain results.
Parameter
SPLit | SINGle
Example
DISP:FORM SPL
Displays noise and gain results in separate graphs.