Rohde & Schwarz R&S FSL3 - Page 1295

DISPlay Subsystem (Noise Figure, K30) R&S FSL
1300.2519.12 6.536 E-11
C
haracteristics
*RST value: SING
SCPI: device–specific
M
ode
NF
DISPlay[:WINDow<1>]:TABLe
This command activates or deactivates the tabular result display.
Parameter
ON | OFF
Example
DISP:TABL ON
Displays the table of results.
Characteristics
*RST value: OFF
SCPI: device–specific
Mode
NF
DISPlay[:WINDow<1>]:TRACe<1|2>[:STATe]
This command activates or deactivates the display of the corresponding trace and related
information.
The numeric suffixes <1|2> indicate the measurement results: Trace 1 is always used for noise
results, and trace 2 is always used for gain results.
Parameter
ON | OFF
Example
DISP:TRAC OFF
Switches off the display of trace 1 (noise results).
DISP:TRAC2 OFF
Switches off the display of trace 2 (gain results).
Characteristics
*RST value: ON for both traces
SCPI: conform
Mode
NF