CONFigure:BTOoth Subsystem (BLUETOOTH, K8) R&S FSL
1300.2519.12 6.366 E-11
Characteristics
*RST value:
0 Output Power
10 Adjacent Channel Power
Modulation Characteristics
Initial Carrier Frequency Tolerance
Carrier Frequency Drift
EDR Relative TX Power
EDR In–band Spurious Emissions
100 Differential Phase Encoding
Mode
BT
CONFigure:BTOoth:SWEep:TIME
This command defies the duration of a sweep sequence for the active Bluetooth measurement.
Parameter
<numeric_value>
(1us to 130560us) /
(points per symbol)
Output Power
Modulation Characteristics
Initial Carrier Frequency Tolerance
Carrier Frequency Drift
EDR Relative TX Power
EDR Differential Phase Encoding
EDR Carrier Frequency Stability and Modulation
Accuracy
10µs ... 16000s
Adjacent Channel Power
Direct programming using the [SENSe<1|2>:]SWEep:TIME command will cancel the coupling
to the settings according to the RF Test Specification.
Note: The setting is valid only for the currently active measurement (see
CONFigure:BTOoth:MEASurement command) and independent of the other
Bluetooth measurements.
Example
INST:SEL BTO
Activates the Bluetooth Measurements option.
CONF:BTO:MEAS OPOW
Activates the Output Power measurement.
CONF:BTO:SWE:TIME 10MS
Sets a sweep time of 10 ms.
Characteristics
*RST value: – (AUTO is set to ON)
SCPI: device–specific
Mode
BT
To Next Page
Loading...
