Rohde & Schwarz R&S FSL3 - Page 1126

R&S FSL CONFigure:BTOoth Subsystem (BLUETOOTH, K8)
1300.2519.12 6.367 E-11
CONFigure:BTOoth:SWEep:TIME:AUTO
This command couples the sweep time to the settings according to the RF Test Specification.
Note: The setting is valid only for the currently active measurement (see
CONFigure:BTOoth:MEASurement command) and independent of the other
Bluetooth measurements.
Parameter
ON | OFF
Example
INST:SEL BTO
Activates the Bluetooth Measurements option.
CONF:BTO:MEAS OPOW
Activates the Output Power measurement.
CONF:BTO:SWE:TIME:AUTO ON
Switches the sweep time coupling on.
Characteristics
*RST value: ON
SCPI: device–specific
Mode
BT
CONFigure:BTOoth:TRACe<1...6>:MODE
This command defines the way of displaying and evaluating the measurement curves for the
selected Bluetooth measurement. WRITe corresponds to manual operating mode Clr/Write.
The numeric suffix selects the trace related to this setting.
The number of measurement to be executed for AVERage, MAXHold and MINHold is defined
with the CONFigure:BTOoth:SWEep:COUNt command. Please note that a synchronization to
the end of the indicated number of measurements is only possible during single sweep
operation.
Note: The setting is valid only for the currently active measurement (see
CONFigure:BTOoth:MEASurement command) and independent of the other
Bluetooth measurements.
Parameter
WRITe | VIEW | AVERage | MAXHold | MINHold | BLANk
Example
INST:SEL BTO
Activates the Bluetooth Measurements option.
CONF:BTO:MEAS OPOW
Activates the Output Power measurement.
INIT:CONT OFF
Selects single sweep operation.
CONF:BTO:SWE:COUN 10
Sets the sweep count to 10.
CONF:BTO:TRAC2:MODE AVER
Switches averaging for trace 2 on.
INIT;*OPC
Starts a measurement with synchronization.