CONFigure:BTOoth Subsystem (BLUETOOTH, K8) R&S FSL
1300.2519.12 6.362 E-11
CONFigure:BTOoth:POWer:AVERage:STARt
This command defines the start position for the calculation of the average power of a burst.
Note: Depending on the setting FIND SYNC ON or OFF
([SENSe<1|2>:]DDEMod:SEARch:SYNC[:STATe] command) the burst is either
defined by the p0 bit and the packet length or the 3 dB points according to the RF Test
Specification. As a result there are different areas within the burst for calculating the
average power:
Burst Length
(=Paket Length)
with FIND SYNC ON
Burst Length
with FIND SYNC OFF
3dB
Parameter
0 to 100PCT
Example
CONF:BTO:POW:AVER:STAR 10PCT
Sets the starting point for the calculation to 10% of the burst length.
Characteristics
*RST value: 20%
SCPI: device–specific
Mode
BT
CONFigure:BTOoth:POWer:AVERage:STOP
This command defines the end position for the calculation of the average power of a burst.
Note: Depending on the setting FIND SYNC ON or OFF
([SENSe<1|2>:]DDEMod:SEARch:SYNC[:STATe] command) the burst is either
defined by the p0 bit and the packet length or the 3 dB points according to the RF Test
Specification. As a result there are different areas within the burst for calculating the
average power (see CONFigure:BTOoth:POWer:AVERage:STARt command).
Parameter
0 to 100PCT
Example
CONF:BTO:POW:AVER:STAR 90PCT
Sets the end point for the calculation to 90% of the burst length.
To Next Page
Loading...
