Rohde & Schwarz R&S FSL3 - Page 1133

SENSe Subsystem (BLUETOOTH, K8) R&S FSL
1300.2519.12 6.374 E-11
C
haracteristics
*RST value: ON
SCPI: device–specific
M
ode
BT
[SENSe<1|2>:]DDEMod:SEARch:PULSe:OFFSet
This command defines the time to be recorded before a signal burst is recognized. The valid
value range is 0 to ± 10 ms.
The numeric suffixes <1|2> are irrelevant for this command.
Parameter
0 to 10 ms
Example
DDEM:SEAR:PULS:OFFS 1MS
Sets the burst offset to 1ms before the start of the burst.
Characteristics
*RST value: 0
SCPI: device–specific
Mode
BT
[SENSe<1|2>:]DDEMod:SEARch:SYNC[:STATe]
This command switches the search for a sync pattern on or off.
The numeric suffixes <1|2> are irrelevant for this command.
Parameter
ON | OFF
Example
DDEM:SEAR:SYNC ON
Switches the sync pattern search on.
Characteristics
*RST value: OFF
SCPI: device–specific
Mode
BT