Rohde & Schwarz R&S FSL3 - Page 1134

R&S FSL SENSe Subsystem (BLUETOOTH, K8)
1300.2519.12 6.375 E-11
[
SENSe<1|2>:]DDEMod:SEARch:SYNC:LAP
This command determines the 24 least significant bits (LAP) of the DUT 'Bluetooth device
address'. They are used to define the synchronization pattern to determine the start of a packet.
The value range is 0 to FFFFFF hex.
The numeric suffixes <1|2> are irrelevant for this command.
P
arameter
<hex>
Example
DDEM:SEAR:SYNC:LAP #HA3F45B
Sets on LAP A3F45B Hex
Characteristics
*RST value: #H0
SCPI: device–specific
Mode
BT
[SENSe<1|2>:]DDEMod:SEARch:SYNC:OFFSet
This command defines the number of bits to be recorded before the first preamble bit is
detected. The valid value range is 0 to ± 10000.
The numeric suffixes <1|2> are irrelevant for this command.
Parameter
0 to 10,000
Example
DDEM:SEAR:SYNC:OFFS 10
Sets the sync offset to 10 bits before the preamble bits.
Characteristics
*RST value: 0
SCPI: device–specific
Mode
BT
[SENSe<1|2>:]DDEMod:SEARch:TIME
This command selects manual setting of the record length and defines the record length to be
used for the search of sync word and burst. The input of the record length is expected in
seconds.
The numeric suffixes <1|2> are irrelevant for this command.
Note: For information on the correlation of trigger and record length refer to the
[SENSe<1|2>:]DDEMod:SEARch:TIME:AUTO command.