SENSe Subsystem (BLUETOOTH, K8) R&S FSL
1300.2519.12 6.376 E-11
P
arameter
100µs to 130560µs / (points per symbol)
Points per Symbol Maximum record length
2 104.4 slots
4 52.2 slots
8 26.1 slots
16 13.1 slots
32 6.5 slots
Example
DDEM:SEAR:TIME 100US
Sets the record length for sync word and burst search to 100µs.
Characteristics
*RST value: 1875µs
SCPI: device–specific
Mode
BT
[SENSe<1|2>:]DDEMod:SEARch:TIME:AUTO
This command activates the automatic setting of the record length for the sync word and burst
search, depending on the selected packet type.
The automatic record length is determined a follows:
Trigger free run:
search length = 3 * packet length + | sync offset or burst offset |
All other trigger modes:
search length = 1 * packet length + 1 Slot + | sync offset or burst offset |
If the selected measurement time is higher than the packet length, the following difference is
added to the search length:
measurement time – packet length
The numeric suffixes <1|2> are irrelevant for this command.
Parameter
ON | OFF
Example
DDEM:SEAR:TIME:AUTO OFF
Selects manual input for the record length
Characteristics
*RST value: ON
SCPI: device–specific
Mode
BT
To Next Page
Loading...
