Rohde & Schwarz R&S FSL3 - Page 1132

R&S FSL SENSe Subsystem (BLUETOOTH, K8)
1300.2519.12 6.373 E-11
SENSe:DDEMod Subsystem (BLUETOOTH, K8)
This subsystem controls the parameters for digital demodulators.
Commands of the SENSe:DDEMod Subsystem
– [SENSe<1|2>:]DDEMod:FILTer:MEASurement
– [SENSe<1|2>:]DDEMod:SEARch:PULSe[:STATe]
– [SENSe<1|2>:]DDEMod:SEARch:PULSe:OFFSet
– [SENSe<1|2>:]DDEMod:SEARch:SYNC[:STATe]
– [SENSe<1|2>:]DDEMod:SEARch:SYNC:LAP
– [SENSe<1|2>:]DDEMod:SEARch:SYNC:OFFSet
– [SENSe<1|2>:]DDEMod:SEARch:TIME
– [SENSe<1|2>:]DDEMod:SEARch:TIME:AUTO
[SENSe<1|2>:]DDEMod:FILTer:MEASurement
This command selects the receive filter for the signal to measure.
The numeric suffixes <1|2> are irrelevant for this command.
Note: This command is only available with active Modulation Characteristics, Initial Carrier
Frequency Tolerance, and Carrier Frequency Drift measurement (see
CONFigure:BTOoth:MEASurement command). With all other measurements it will
lead to a query error.
Parameter
OFF | BTOoth
Example
DDEM:FILT:MEAS BTO
Activates the Bluetooth measurement filter.
Characteristics
*RST value: ON
SCPI: device–specific
Mode
BT
[SENSe<1|2>:]DDEMod:SEARch:PULSe[:STATe]
This command switches the search for a signal burst on or off.
The numeric suffixes <1|2> are irrelevant for this command.
Parameter
ON | OFF
Example
DDEM:SEAR:PULS OFF