SENSe Subsystem (BLUETOOTH, K8) R&S FSL
1300.2519.12 6.372 E-11
Parameter
ON | OFF
Example
ADEM:ZOOM ON
Switches on the zoom function
Characteristics
*RST value: OFF
SCPI: device–specific
Mode
BT
[SENSe:]ADEMod:ZOOM:STARt
The command sets the start time for the display of individual measured values.
The zoom function is enabled or disabled by the [SENSe:]ADEMod:ZOOM[:STATe]
command.
Note: The zoom function is only available for the Output Power, Modulation Characteristics,
Initial Carrier Frequency Tolerance, and Carrier Frequency Drift measurements.
Parameter
0 s to (meas time – 500 / sampling rate)
Example
ADEM:ZOOM ON
Switches on the zoom function
ADEM:ZOOM:STAR 500us
Sets the starting point of the display to 500 µs.
Characteristics
*RST value: 0 s
SCPI: device–specific
Mode
BT
To Next Page
Loading...
