R&S FSL CONFigure:BTOoth Subsystem (BLUETOOTH, K8)
1300.2519.12 6.359 E-11
C
ONFigure:BTOoth:CHANnel
This command selects the frequency channel for the measurements according to the Bluetooth
standard.
Parameter
0 to 78
Example
CONF:BTO:CHAN 20
Selects channel 20
Characteristics
*RST value: 0
SCPI: device–specific
Mode
BT
CONFigure:BTOoth:DETector<1...6>[:FUNCtion]
This command selects the detector for the currently selected Bluetooth measurement. The
numeric suffix assigns the detector to a trace (1 to 6).
Note: The RMS detector is not available for the measurements Modulation Characteristics,
Initial Carrier Frequency Tolerance, and Carrier Frequency Drift (see
CONFigure:BTOoth:MEASurement command).
The setting is valid for the currently selected measurement (see
CONFigure:BTOoth:MEASurement command) and independent of other Bluetooth
measurements.
Parameter
APEak | NEGative | POSitive | SAMPle | RMS | AVERage
Example
CONF:BTO:MEAS OPOW
Activates the Output Power measurement.
CONF:BTO:DET2 RMS
Sets the detector for trace 2 to RMS.
Characteristics
*RST value:
PEAK Output Power
AVER Adjacent Channel Power
EDR Rel TX Power
EDR In–band Spurious Emissions
APEAK Modulation Characteristics
Initial Carrier Frequency Tolerance
Carrier Frequency Drift
EDR Differential Phase Encoding
EDR Carrier Frequency Stability and
Modulation Accuracy
SCPI: device–specific
Mode
BT
To Next Page
Loading...
