Bluetooth Measurements (Option K8) R&S FSL
1300.2519.12 4.160 E-11
4. Select the packet length.
– Press Packet Type softkey.
The list of available packet type is displayed.
– Select the desired packet length and confirm the selection with ENTER.
5. Select the power class of the DUT.
– Press Power Class softkey and enter the power class.
6. Configure the sync settings (LAP).
– Press Find Sync softkey.
The submenu menu for configuration of the sync information is displayed.
– Press LAP softkey and enter the lower address part of the Bluetooth device address of the
DUT. The sync word used for the sync search will be calculated.
7. Select a measurement.
– Press the MEAS key and select the desired measurement in the softkey menu.
– Configure measurement time, measurement control and the number of measurement cycles by
pressing the corresponding softkeys. For further information refer to section "Softkeys of the
measurement menu (Bluetooth mode)" on page 4.181.
Further information
This section provides background information on measurements and displayed information.
Position of a Bluetooth burst
The RF Test Specification allows different methods to determine the position of a Bluetooth burst:
• The burst is defined by the p0 bit and the automatically determined packet length (Find Sync On).
• The burst is defined by the two 3dB points (Find Sync Off and Find Burst On). The search of the
3dB points is defined in the RF Test Specification as the alternative method compared with the p0
bit method.
Burst length
(=packet length)
with FIND SYNC ON
Burst length
with FIND SYNC OFF
3dB
Fig. 4-11 Definition of a Bluetooth burst
To Next Page
Loading...
