Bluetooth Measurements (Option K8) R&S FSL
1300.2519.12 4.168 E-11
Packet Bytes SCO
Opens an edit dialog box to set the number of payload bytes that are transmitted in a packet.
For SCO packets, the payload length must be adjusted because those packets have no payload
header.
Remote: CONF:BTO:PBSC 50
Power Class (Output Power)
Opens an edit dialog box to set one the Bluetooth power classes (1 to 3). The selection of the
power class determines the limits. The default setting is power class 1 (100 mW).
Remote: CONF:BTO:PCL 3
Antenna Gain
Opens an edit dialog box to enter a level offset in order to take the gain of an antenna into
account for displaying power values. The default setting is 0 dB (see also Labels used in the
measurement displays).
Remote: CORR:EGA:INP 10DB
Find Sync
Opens a submenu to set the signal processing functions of the analyzer in order to determine
the position of the first preamble bit p0 by correlation with the sync word. For this purpose a
sufficient record length of the FM demodulated signal is necessary.
For further information refer to "Position of a Bluetooth burst" on page 4.160.
Find Sync On/Off
Activates or deactivates the search of the sync word. The default setting is activated.
The results of the modulation measurements Modulation Characteristics, Initial Carrier
Frequency Tolerance, Carrier Frequency Drift can only be calculated if the softkey is activated.
The measurement of the Output Power can be performed with either this softkey or the Find
Burst On/Off softkey activated. If both softkeys are activated, the search area for the sync word
will be limited to the area of the detected burst. If the Find Burst On/Off softkey is not activated
or no burst is identified, the total record length (search length) is investigated.
For further information refer to "Position of a Bluetooth burst" on page 4.160.
Remote: DDEM:SEAR:SYNC ON
To Next Page
Loading...
