R&S FSL Bluetooth Measurements (Option K8)
1300.2519.12 4.167 E-11
Softkeys of the Bluetooth menu
This menu provides the softkeys for the basic settings, which are common to all tests. The following
table shows all softkeys available in the Bluetooth menu. It is possible that your instrument configuration
does not provide all softkeys. If a softkey is only available with a special option, model or
(measurement) mode, this information is delivered in the corresponding softkey description.
Menu / Command Command
Channel
Packet Type
Packet Bytes SCO
Power Class
Antenna Gain
Find Sync Find Sync On/Off
LAP
Sync Offset
Find Burst On/Off
Burst Offset
Search Len Auto
Search Len Manual
More
Select Trace
Points / Symbol
Channel
Opens an edit dialog box to enter the transmission channel number. From the number of the
channel the center frequency is calculated in accordance to the RF Test Specification. The
default setting is channel number 0.
Setting the channel number is in principle equal to changing the center frequency. The major
difference is that the center frequency is not limited to available frequency band values, i.e.
values outside the frequency band and between the discrete channels can be selected (see also
Center softkey in the frequency menu).
Remote: CONF:BTO:CHAN 20
Packet Type
Opens a dialog box to select the number of occupied slots in the sent packet. The AUTO value
is identical to 5 Slot Packet. The default value is packet type 1 Slot Packet.
The number of occupied slots is used for the automatic calculation of the sweep time
(Sweeptime Auto softkey) and the search length of the sync word (Search Len Auto softkey).
The actually transmitted packet type is determined automatically by the Bluetooth demodulator
(which means that the selected packet type need not necessarily correspond to the really
transmitted packet type; it will only affect the settings for sweep time and search length as
described above).
Remote: CONF:BTO:PTYP DH5
To Next Page
Loading...
