R&S FSL Bluetooth Measurements (Option K8)
1300.2519.12 4.181 E-11
Trigger Source
Opens the Trigger dialog box to select one of the following trigger sources: Free Run, External,
IF Power.
For further details refer to the Trg / Gate Source softkey in the trigger menu of the base unit.
Trg/Gate Level
Opens an edit dialog box to enter the trigger / gate level. This softkey is not available, if the
trigger source Free Run is selected.
For further details refer to the Trg / Gate Level softkey in the trigger menu of the base unit.
Trigger Polarity
For details refer to the Trg / Gate Polarity Pos/Neg softkey in the trigger menu of the base unit.
Trigger Offset
For details refer to the Trigger Offset softkey in the trigger menu of the base unit.
Softkeys of the measurement menu (Bluetooth mode)
The following table shows all softkeys available in the measurement menu in Bluetooth mode (MEAS
key). It is possible that your instrument configuration does not provide all softkeys. If a softkey is only
available with a special option, model or (measurement) mode, this information is delivered in the
corresponding softkey description.
In the Bluetooth mode, the sweep menu is used for direct entry into the measurement menu of the
currently selected measurement. Therefore only the softkeys to select a measurement are described in
this section. All other softkeys are linked to the description in section Softkeys of the sweep menu
(Bluetooth mode) or Softkeys of the bandwidth menu (Bluetooth mode).
Menu / Command Submenu / Command Command
Output Power Continuous Sweep
Single Sweep
Meas Time Manual
Meas Time Auto
Sweep Count
Power Avg Start
Power Avg Stop
TX Spec ACP Continuous Sweep
Single Sweep
Sweeptime Manual
Sweeptime Auto
Sweep Count
No. of ACP Chan
To Next Page
Loading...
