Bluetooth Measurements (Option K8) R&S FSL
1300.2519.12 4.180 E-11
Gate Length (Spurious Emissions)
Opens an edit dialog box to enter the sweep time in seconds. Usually, this is the length of the
DPSK section.
Remote: SWE:EGAT:LENG 10ms
GFSK Start (Rel TX Power)
Opens an edit dialog box to enter the start time for the power measurement of the GFSK
sections of the packet. The default value is 10%.
The abbreviation GFSK stands for Gaussian Frequency Shift Keying.
Remote: CONF:BTO:RTP:GAV:STAR 20
GFSK Stop (Rel TX Power)
Opens an edit dialog box to enter the stop time for the power measurement of the GFSK
sections of the packet. The default value is 90%.
The abbreviation GFSK stands for Gaussian Frequency Shift Keying.
Remote: CONF:BTO:RTP:GAV:STOP 80
DPSK Start (Rel TX Power)
Opens an edit dialog box to enter the start time for the power measurement of the DPSK
sections of the packet. The default value is 10%.
The abbreviation DPSK stands for Differential Phase Shift Keying.
Remote: CONF:BTO:RTP:DAV:STAR 20
DPSK Stop (Rel TX Power)
Opens an edit dialog box to enter the stop time for the power measurement of the DPSK
sections of the packet. The default value is 90%.
The abbreviation DPSK stands for Differential Phase Shift Keying.
Remote: CONF:BTO:RTP:DAV:STOP 80
Softkeys of the trigger menu (Bluetooth mode)
The following table shows all softkeys available in the trigger menu in Bluetooth mode (FREQ key). It
is possible that your instrument configuration does not provide all softkeys. If a softkey is only available
with a special option, model or (measurement) mode, this information is delivered in the corresponding
softkey description.
Command
Trigger Source
Trg/Gate Level
Trigger Polarity
Trigger Offset
To Next Page
Loading...
