R&S FSL Bluetooth Measurements (Option K8)
1300.2519.12 4.177 E-11
Softkeys of the sweep menu (Bluetooth mode)
The following table shows all softkeys available in the sweep menu in Bluetooth mode (SWEEP key).
In the Bluetooth mode, the sweep menu is used for direct entry into the measurement menu of the
currently selected measurement. It is possible that your instrument configuration does not provide all
softkeys. If a softkey is only available with a special option, model or (measurement) mode, this
information is delivered in the corresponding softkey description.
Command
Start Test
Continue Test
Continuous Sweep
Single Sweep
Meas Time Manual
Meas Time Auto
Sweeptime Manual
Sweeptime Auto
Block Count
Adjust Gate
Sweep Count
Power Avg Start
Power Avg Stop
Zoom
No. of ACP Chan
Channel List Start
More
Gate Delay
Gate Length
GFSK Start
GFSK Stop
DPSK Start
DPSK Stop
Start Test (Modulation Char)
Initiates a new measurement. All frequency deviation values obtained earlier are discarded.
The bit pattern in the payload is detected automatically. The frequency deviation of a packet is
determined according to the procedure defined in the RF Test Specification.
Remote: INIT;*WAI
To Next Page
Loading...
