R&S FSL SENSe Subsystem (Power Meter, K9)
1300.2519.12 6.387 E-11
[
SENSe<1|2>:]PMETer:TRIGger:LEVel
This command sets the power level of the external power trigger.
T
he numeric suffixes <1|2> are irrelevant.
This command is only available in conjunction with a NRP-Z81 power sensor.
This command is available from firmware version 1.90.
Parameter
-20 bis + 20 dBm
Example
PMET:TRIG:LEV -10 dBm
Sets the level of the trigger.
Characteristics
*RST value: -20dBm
SCPI: device–specific
Mode
PSM
To Next Page
Loading...
