R&S FSL Notation
1300.2519.12 6.1 E-11
6 Remote Control – Commands
This chapter describes all remote control commands for the analyzer functions, firmware options (see
list below) and the basic settings functions of the R&S FSL in detail. Commands that are used both for
analyzer functions and firmware options are described in the analyzer commands section. The mode
information is provided for each command.
A few commands are implemented for reasons of compatibility with the R&S FSP family only. These
commands are not described in the R&S FSL documentation, because they have no effect.
Each subsystem starts with a list of commands, which provides quick access to all commands of the
subsystem. Be aware, that for one subsystem more than one SCPI command lists can exist, depending
on the functionality (analyzer and basic settings, options). For details on the notation refer to "Notation".
Remote commands of firmware and firmware options
– "Remote Commands of the Base Unit" on page 6.5
– "Remote Commands of the Analog Demodulation Option (K7)" on page 6.284
– "Remote Commands of the Bluetooth Measurements Option (K8)" on page 6.332
– "Remote Commands of the Power Meter Option (K9)" on page 6.377
– "Remote Commands of the Spectrogram Measurement Option (K14)" on page 6.389
– "Remote Commands of the Cable TV Measurements Option (K20)" on page 6.410
– "Remote Commands of the Noise Figure Measurements Option (K30)" on page 6.521
– "Remote Commands of the 3GPP Base Station Measurements Option (K72)" on page 6.564
– "Remote Commands of the CDMA2000 BTS Analyzer Option (K82)" on page 6.596
– "Remote Commands of the 1xEV-DO BTS Analyzer Option (K84)" on page 6.633
– "Remote Commands of the WLAN TX Measurements Option (K91 / K91n)" on page 6.671
– "Remote Commands of the WiMAX, WiBro Measurements Option (K92/K93)" on page 6.755
To Next Page
Loading...
