Remote Commands of the Analog Demodulation Option (K7) R&S FSL
1300.2519.12 6.284 E-11
Remote Commands of the Analog Demodulation
Option (K7)
In this section all remote control commands for Analog Demodulation option are described in detail. The
abbreviation ADEMOD stands for the Analog Demodulation operating mode. For details on conventions
used in this chapter refer to section "Notation" on page 6.2 at the beginning of this chapter.
For further information on analyzer or basic settings commands, refer to the corresponding subsystem
in "Remote Commands of the Base Unit" on page 6.5.
This option is available from firmware version 1.10.
Subsystems of the Analog Demodulation option (K7)
– "CALCulate Subsystem (Analog Demodulation, K7)" on page 6.285
– "DISPlay Subsystem (Analog Demodulation, K7)" on page 6.295
– "INSTrument Subsystem (Analog Demodulation, K7)" on page 6.297
– "SENSe Subsystem (Analog Demodulation, K7)" on page 6.298
– "TRACe Subsystem (Analog Demodulation, K7)" on page 6.328
– "TRIGger Subsystem (Analog Demodulation, K7)" on page 6.329
– "UNIT Subsystem (Analog Demodulation, K7)" on page 6.331
To Next Page
Loading...
