CALCulate Subsystem (Noise Figure, K30) R&S FSL
1300.2519.12 6.528 E-11
CALCulate:LIMit:UPPer Subsystem (Noise Figure, K30)
The CALCulate:LIMit:UPPer subsystem defines the upper limit line. If a set command is issued in this
subsystem the limit line effected is automatically converted to an upper limit line.
Commands of the CALCulate:LIMit:UPPer Subsystem
– CALCulate<1|2>:LIMit<1...6>:UPPer[:DATA]
– CALCulate<1|2>:LIMit<1...6>:UPPer:SHIFt
– CALCulate<1|2>:LIMit<1...6>:UPPer:STATe
CALCulate<1|2>:LIMit<1...6>:UPPer[:DATA]
Different to the basic unit, only 6 limit lines can be active at the same time (indicated by LIMIT1
to LIMIT6).
For further details refer to "CALCulate<1|2>:LIMit<1...8>:UPPer[:DATA]" on page 6.51.
CALCulate<1|2>:LIMit<1...6>:UPPer:SHIFt
Different to the base unit, only 6 limit lines can be active at the same time (indicated by LIMIT1
to LIMIT6).
For further details refer to "CALCulate<1|2>:LIMit<1...8>:UPPer:SHIFt" on page 6.53.
CALCulate<1|2>:LIMit<1...6>:UPPer:STATe
Different to the base unit, only 6 limit lines can be active at the same time (indicated by LIMIT1
to LIMIT6).
For further details refer to "CALCulate<1|2>:LIMit<1...8>:UPPer:STATe" on page 6.54.
To Next Page
Loading...
