Rohde & Schwarz R&S FSL3 - Page 788

R&S FSL CALCulate Subsystem
1300.2519.12 6.29 E-11
C
ALCulate<1|2>:LIMit<1...8>:ACTive?
This command queries the names of all active limit lines.
T
he numeric suffixes <1|2> and <1...8> are irrelevant for this command.
This command is only a query and therefore has no *RST value.
This command is available from firmware version 1.60.
Example
CALC:LIM:ACT?
Queries the names of all active limit lines.
Return values
'3GBAA,3GBBA,3GBCR'
Returns the names of the active limit lines in alphabetical order, separated by commas.
Characteristics
RST value: –
SCPI: device–specific
Mode
A, CDMA, EVDO
CALCulate<1|2>:LIMit<1...8>:CLEar[:IMMediate]
This command deletes the result of the current limit check for all limit lines.
The numeric suffixes <1|2> and <1...8> are irrelevant for this command.
This command is an event and therefore has no *RST value.
This command is available from firmware version 1.10.
Example
CALC:LIM:CLE
Deletes the result of the limit check.
Characteristics
*RST value: –
SCPI: conform
Mode
A, ADEMOD, CDMA, EVDO, NF
CALCulate<1|2>:LIMit<1...8>:COMMent
This command defines a comment for the limit line selected (max. 40 characters).
The numeric suffixes <1|2> are irrelevant for this command.
This command is available from firmware version 1.10.
Parameter
<string>, max. 40 alphanumeric characters
Example
CALC:LIM5:COMM 'Upper limit for spectrum'
Defines the comment for limit line 5.