CALCulate Subsystem (Noise Figure, K30) R&S FSL
1300.2519.12 6.526 E-11
CALCulate:LIMit:CONTrol Subsystem (Noise Figure, K30)
The CALCulate:LIMit:CONTrol subsystem defines the x–axis (CONTrol axis).
Commands of the CALCulate:LIMit:CONTrol Subsystem
– CALCulate<1|2>:LIMit<1...6>:CONTrol[:DATA]
– CALCulate<1|2>:LIMit<1...6>:CONTrol:SHIFt
CALCulate<1|2>:LIMit<1...6>:CONTrol[:DATA]
Different to the base unit, only 6 limit lines can be active at the same time (indicated by LIMIT1
to LIMIT6).
For further details refer to "CALCulate<1|2>:LIMit<1...8>:CONTrol[:DATA]" on page 6.41.
CALCulate<1|2>:LIMit<1...6>:CONTrol:SHIFt
Different to the base unit, only 6 limit lines can be active at the same time (indicated by LIMIT1
to LIMIT6).
For further details refer to "CALCulate<1|2>:LIMit<1...8>:CONTrol:SHIFt" on page 6.43.
To Next Page
Loading...
