Rohde & Schwarz R&S FSL3 - Page 1497

SENSe Subsystem (WLAN, K91 / K91n) R&S FSL
1300.2519.12 6.738 E-11
C
haracteristics
*RST value: 100µs
S
CPI: device–specific
Mode
WLAN
[SENSe:]SWEep:EGATe:HOLDoff:SAMPle
This command defines the gate delay in the capture buffer as a number of samples. The range
of this value is dependent on the last run measurement.
Parameter
<numeric_value>
Example
SWE:EGAT:HOLD:SAMP 2500
Sets a delay of 2500 samples in the capture buffer.
Characteristics
*RST value: 2000
SCPI: device–specific
Mode
WLAN
[SENSe:]SWEep:EGATe:LENGth[:TIME]
This command defines the gate time in the capture buffer in time units. The range of this value
is dependent on the last run measurement.
Parameter
<numeric_value>
Example
SWE:EGAT:LENG 20ms
Sets a gate length of 20 milliseconds between sweeps.
Characteristics
*RST value: 400µs
SCPI: device–specific
Mode
WLAN
[SENSe:]SWEep:EGATe:LENGth:SAMPle
This command defines the gate time in the capture buffer as a number of samples. The range of
this value is dependent on the last run measurement.
Parameter
<numeric_value>
Example
SWE:EGAT:LENG:SAMP 200000
Sets a gate length of 200000 samples in the capture buffer.