Rohde & Schwarz R&S FSL3 - Page 1498

R&S FSL SENSe Subsystem (WLAN, K91 / K91n)
1300.2519.12 6.739 E-11
Characteristics
*RST value: 8000
SCPI: device–specific
Mode
WLAN
[SENSe:]SWEep:EGATe:LINK
This command links together the movement of the gating lines and the capture buffer marker.
Parameter
ON | OFF
Example
SWE:EGAT:LINK ON
Links the gating lines as marker with the gating line delay and length are changed gate position.
Characteristics
*RST value: 0
SCPI: device–specific
Mode
WLAN
[SENSe:]SWEep:TIME
The RST value for the WLAN TX Measurements option (K91 / K91n) is 1 ms.
For further details refer to "[SENSe<1|2>:]SWEep:TIME" on page 6.234.
[SENSe:]TRACking:LEVel
This command defines whether or not the measurement results should be compensated for
level.
Parameter
ON | OFF
Example
TRAC:LEV ON
Specifies that the measurement results should be compensated for level.
Characteristics
*RST value: OFF
SCPI: device–specific
Mode
WLAN