Rohde & Schwarz R&S FSL3 - Page 1499

SENSe Subsystem (WLAN, K91 / K91n) R&S FSL
1300.2519.12 6.740 E-11
[
SENSe:]TRACking:PHASe
This command defines whether or not the measurement results should be compensated for
phase.
Parameter
ON | OFF
Example
TRAC:PHAS ON
Specifies that the measurement results should be compensated for phase.
Characteristics
*RST value: ON
SCPI: device–specific
Mode
WLAN
[SENSe:]TRACking:TIME
This command defines whether or not the measurement results should be compensated for
time.
Parameter
ON | OFF
Example
TRAC:TIME ON
Specifies that the measurement results should be compensated for time.
Characteristics
*RST value: OFF
SCPI: device–specific
Mode
WLAN