R&S FSL SENSe Subsystem (WLAN, K91 / K91n)
1300.2519.12 6.737 E-11
[
SENSe:]SWAPiq
This command defines whether or not the recorded IQ pairs should be swapped (I<–>Q) before
being processed.
Parameter
ON | OFF
Example
SWAP ON
Specifies that IQ values should be swapped.
Characteristics
*RST value: OFF
SCPI: device–specific
Mode
WLAN
[SENSe:]SWEep:COUNt
This command specifies the number of sweeps for Spectrum Mask and Spectrum ACPR
measurements.
Parameter
<numeric_value>
Example
SWEep:COUNt 64
Sets the number of sweeps to 64.
Characteristics
*RST value: 1
SCPI: conform
Mode
WLAN
[SENSe:]SWEep:EGATe
For details refer to "[SENSe<1|2>:]SWEep:EGATe" on page 6.230.
[SENSe:]SWEep:EGATe:HOLDoff[:TIME]
This command defines the gate delay in the capture buffer in time units. The range of this value
is dependent on the last run measurement.
Parameter
<numeric_value>
Example
SWE:EGAT:HOLD 125us
Sets a delay of 125µs in the capture buffer.
To Next Page
Loading...
