SENSe Subsystem (WLAN, K91 / K91n) R&S FSL
1300.2519.12 6.736 E-11
[
SENSe:]DEMod:FORMat:SIGSymbol
If this command is set to ON, the signal symbol field of the burst is analyzed to determine the
details of the burst. Only burst which match the supplied burst type and modulation are
considered in results analysis. For IEEE 802.11b this command can only be queried as the
decoding of the signal field is always performed for the IEEE 802.11b standard.
Parameter
ON | OFF
Example
DEM:FORM:SIGS ON
Specifies that the signal symbol field should be decoded.
Characteristics
*RST value: –
SCPI: device–specific
Mode
WLAN
[SENSe:]FREQuency:CENTer
For details refer to "[SENSe<1|2>:]FREQuency:CENTer" on page 6.200.
[SENSe:]POWer:ACHannel:MODE
This command sets the ACP measurement mode for the IEEE 802.11j standard to either
absolute or relative.
Parameter
ABS Absolute measurement
REL Relative measurement
Example
POW:ACH:MODE ABS
Sets the ACP measurement to absolute mode
Characteristics
*RST value: REL
SCPI: device–specific
Mode
WLAN
To Next Page
Loading...
