Rohde & Schwarz R&S FSL3 - Page 1489

SENSe Subsystem (WLAN, K91 / K91n) R&S FSL
1300.2519.12 6.730 E-11
Parameter
<numeric_value>
Example
DEM:BAN:DUR:MIN 45
Only bursts which last 48 microseconds are analyzed.
Characteristics
*RST value: 1
SCPI: device–specific
Mode
WLAN
[SENSe:]DEMod:CESTimation
This command defines whether channel estimation will be done in preamble and payload (if set
to 1) or only in preamble (if set to 0). The effect of this is most noticeable for the EVM
measurement results, where the results will be improved when this feature is enabled.
However, this functionality is not supported by the IEEE 802.11 standard and must be disabled
if the results are to be strictly measured against the standard.
Parameter
ON | OFF
Example
DEMod:CEST ON
Specifies that the IQ measurement results will use channel estimation in preamble & payload.
Characteristics
*RST value: OFF
SCPI: device–specific
Mode
WLAN
[SENSe:]DEMod:FILTer:CATalog?
This command reads the names of all available filters. The file names are output without file
extension. Syntax of output format: filter_1,filter_2, … ,filter_n.
This command is a query only and thus has no *RST value.
Example
DEM:FILT:CAT?
Reads all filter names
Characteristics
*RST value: 0
SCPI: device–specific
Mode
WLAN