Rohde & Schwarz R&S FSL3 - Page 1487

SENSe Subsystem (WLAN, K91 / K91n) R&S FSL
1300.2519.12 6.728 E-11
Parameter Standard Description
QPSK12 IEEE 802.11a, g (OFDM), j (20 MHz) & Turbo Quadrature phase shift keying at 12 Mbps
QPSK13 IEEE 802.11n Quadrature phase shift keying at 13 Mbps
QPSK18 IEEE 802.11a, g (OFDM), j (20 MHz) & Turbo Quadrature phase shift keying at 18 Mbps
QPSK6 IEEE 802.11j (10 MHz) Quadrature phase shift keying at 6 Mbps
QPSK9 IEEE 802.11j (10 MHz) Quadrature phase shift keying at 9 Mbps
QPSK144 IEEE 802.11n Quadrature phase shift keying at 14.4 Mbps
QPSK195 IEEE 802.11n Quadrature phase shift keying at 19.5 Mbps
QPSK217 IEEE 802.11n Quadrature phase shift keying at 21.7 Mbps
[SENSe:]BURSt:COUNt
This command defines the number of bursts that will be analyzed by the measurement. This
parameter is ignored if the setting for the [SENSe:]BURSt:COUNt:STATe parameter is off.
Parameter
<numeric_value>
Example
BURS:COUN 16
Sets the number of bursts to 16.
Characteristics
*RST value: 1
SCPI: device–specific
Mode
WLAN
[SENSe:]BURSt:COUNt:STATe
When this command is set to on, the burst count parameter will be used by the measurement,
otherwise the burst count parameter will be ignored.
Parameter
ON | OFF
Example
BURS:COUN:STAT ON
Sets the burst count state to ON
Characteristics
*RST value: OFF
SCPI: device–specific
Mode
WLAN