R&S FSL Using Limit Lines and Display Lines – LINES Key
1300.2519.12 4.119 E-11
To work with display lines
Initial situation: The line is switched on (softkey with highlighted background) or off (softkey without
highlighted background), for example the Display Line 1.
1. Press the Display Lines softkey.
2. Press the Display Line 1 softkey for the first time.
An edit dialog box is opened to enter the position of the display line (by rotary knob, step keys or
numerical entry). If the line was switched off, it is switched on. If it was switched on, it remains
switched on.
3. If another softkey is pressed, the edit dialog box for the Display Line 1 softkey is closed, but the
line remains switched on (softkey with highlighted background).
4. Press the Display Line 1 softkey for the second time.
The edit dialog box for the display line will be opened again.
5. Press the Display Line 1 softkey again.
The line is switched off (softkey without highlighted background).
To select a limit line
1. To display the Select Limit Line dialog box, press the LINES key or go to the main limit line menu.
All limit lines, saved in the default directory, and all subdirectories are displayed. For each limit line,
the following information is given:
Unit
unit of the y–axis
Traces
selected traces to check
Show
limit line displayed in the measurement diagram or hidden
Compatible
compatibility of the limit line to the current measurement settings
To Next Page
Loading...
