Rohde & Schwarz R&S FSL3 - Page 1342

R&S FSL SENSe Subsystem (WCDMA, K72)
1300.2519.12 6.583 E-11
SENSe:CDPower Subsystem (WCDMA, K72)
The SENSe:CDPower subsystem controls the parameters for the code domain mode. The numeric
suffix in SENSe<1|2> is not significant in this subsystem.
Commands of the SENSe:CDPower Subsystem
– [SENSe<1|2>:]CDPower:ANTenna
– [SENSe<1|2>:]CDPower:ASEQuence
– [SENSe<1|2>:]CDPower:CODE
– [SENSe<1|2>:]CDPower:HSDPamode
– [SENSe<1|2>:]CDPower:ICTReshold
– [SENSe<1|2>:]CDPower:LCODe[:VALue]
– [SENSe<1|2>:]CDPower:LCODe:DVALue
– [SENSe<1|2>:]CDPower:LCODe:SEARch[:IMMediate]
– [SENSe<1|2>:]CDPower:LCODe:SEARch:LIST?
– [SENSe<1|2>:]CDPower:LEVel:ADJust
– [SENSe<1|2>:]CDPower:NORMalize
– [SENSe<1|2>:]CDPower:PREFerence
– [SENSe<1|2>:]CDPower:QINVert
– [SENSe<1|2>:]CDPower:RSUMmary
– [SENSe<1|2>:]CDPower:SLOT
– [SENSe<1|2>:]CDPower:STYPe
[SENSe<1|2>:]CDPower:ANTenna
This command activates or deactivates the antenna diversity mode and selects the antenna to
be used.
The numeric suffixes <1|2> are irrelevant for this command.
Parameter
OFF The antenna diversity mode is switched off.
1 | 2 The antenna diversity mode is switched on, and the signal from antenna 1 or
antenna 2 is used for code domain power analysis.
Example
CDP:ANT 1
The signal from antenna 1 is used for code domain power analysis.
Characteristics
RST value: OFF
SCPI: device–specific
Mode
WCDMA