Rohde & Schwarz R&S FSL3 - Page 1343

SENSe Subsystem (WCDMA, K72) R&S FSL
1300.2519.12 6.584 E-11
[SENSe<1|2>:]CDPower:ASEQuence
This command starts the following sequence:
– Adjusts the reference level.
– Searches automatically the scrambling code that leads to the highest signal power and stores it
as new scrambling code.
– Changes into the Result Summary result display.
The numeric suffixes <1|2> are irrelevant for this command.
This command is an event and therefore has no *RST value and no query.
Example
CDP:ASEQ
Characteristics
RST value: –
SCPI: device–specific
Mode
WCDMA
[SENSe<1|2>:]CDPower:CODE
This command sets the code number. The code number refers to code class 9 (spreading factor
512).
The numeric suffixes <1|2> are irrelevant for this command.
Parameter
0 to 511
Example
CDP:CODE 30
Sets code number 30.
Characteristics
RST value: 0
SCPI: device–specific
Mode
WCDMA
[SENSe<1|2>:]CDPower:HSDPamode
This command activates or deactivates the HSUPA/DPA channel detection.
The numeric suffixes <1|2> are irrelevant for this command.
Parameter
ON The high speed channels can be detected.
The modulation type (QPSK /16QAM) is detected.
OFF The high speed channel can not be detected.
Pilot symbols are detected.