Rohde & Schwarz R&S FSL3 - Page 1345

SENSe Subsystem (WCDMA, K72) R&S FSL
1300.2519.12 6.586 E-11
[
SENSe<1|2>:]CDPower:LCODe:DVALue
This command defines the scrambling code in decimal format.
T
he numeric suffixes <1|2> are irrelevant for this command.
Parameter
0 to 24575
Example
CDP:LCOD:DVAL 3
Defines the scrambling code in decimal format.
Characteristics
RST value: 0
SCPI: device–specific
Mode
WCDMA
[SENSe<1|2>:]CDPower:LCODe:SEARch[:IMMediate]
This command searches automatically the scrambling code that leads to the highest signal
power and stores it as new scrambling code for further measurements.
The numeric suffixes <1|2> are irrelevant for this command.
This command is an event and therefore has no *RST value and no query.
Example
CDP:LCOD:SEAR
Characteristics
RST value: –
SCPI: device–specific
Mode
WCDMA
[SENSe<1|2>:]CDPower:LCODe:SEARch:LIST?
This command returns a comma separated result table of the automatic search sequence
containing the highest power values calculated and the corresponding scrambling codes.
The numeric suffixes <1|2> are irrelevant for this command.
This command is only a query and therefore has no *RST value.
Returned value
Each found scrambling code consists of the following line:
<decimal scrambling code value>, <hexadecimal scrambling code value>, <power in dBm>
Example:
16,0x10,–18.04,32,0x20,–22.87,48,0x30,–27.62,64,0x40,–29.46
in table format:
code (dec) code (hex) CPICH power (dBm)
16 0x10 –18.04
32 0x20 –22.87
48 0x30 –27.62
64 0x40 –29.46