Rohde & Schwarz R&S FSL3 - Page 1511

TRIGger Subsystem (WLAN, K91 / K91n) R&S FSL
1300.2519.12 6.752 E-11
TRIGger[:SEQuence]:LEVel:POWer
This command accepts the level of the input signal for which triggering will occur.
Parameter
<numeric_value>
Example
TRIG:LEV:POW 10 DBM
Set to 10 dBm for RF measurement.
Characteristics
*RST value: 0 DBM
SCPI: device–specific
Mode
WLAN
TRIGger[:SEQuence]:LEVel:POWer:AUTO
This command specifies whether or not an automatic power trigger level calculation is
performed before each main measurement. The setting of this command is ignored if the setting
for the TRIGger[:SEQuence]:MODE command is not POWer.
Parameter
ON | OFF
Example
TRIG:LEV:POW:AUTO ON
Specifies that an automatic power trigger level calculation should be performed before the start
of each main measurement.
Characteristics
*RST value: OFF
SCPI: device–specific
Mode
WLAN