R&S FSL 3GPP Base Station Measurements (Option K72)
1300.2519.12 4.279 E-11
H
SDPA/HSUPA On/Off
Activates or deactivates the HSUPA/DPA channel detection and the display of the HSUPA/DPA
channels in the channel table.
ON
The high speed channels can be detected (default settings).
The modulation type (QPSK /16QAM) is detected.
OFF
The high speed channel can not be detected.
Pilot symbols are detected.
Remote: CDP:HSDP OFF
Sync Type CPICH/SCH
Defines the synchronization. The default setting of this softkey is CPICH.
CPICH
A synchronization to the CPICH control channel is performed. As a prerequisite,
the CPICH control channel must be present in the signal.
SCH
A synchronization without assuming the presence of a CPICH channel is
performed.
While this setting can also be used with other channel configurations, but the
probability of synchronization failure increases with the number of data channels.
Remote: CDP:STYP SCH
Softkeys of the frequency menu (3G FDD BTS mode)
The following table shows all softkeys available in the frequency menu in 3G FDD BTS mode. It is
possible that your instrument configuration does not provide all softkeys. If a softkey is only available
with a special option, model or (measurement) mode, this information is delivered in the corresponding
softkey description.
Command
Center
Stepsize Manual
Frequency Offset
Center
For details refer to the Center softkey in the frequency menu of the base unit.
Stepsize Manual
For details refer to the Manual softkey in the frequency menu of the base unit.
Frequency Offset
For details refer to the Frequency Offset softkey in the frequency menu of the base unit.
To Next Page
Loading...
