R&S FSL 3GPP Base Station Measurements (Option K72)
1300.2519.12 4.283 E-11
Next Peak Mode < abs >
For further details refer to the Next Peak Mode < abs > softkey in the marker–> menu of the
base unit.
CPICH
Sets the active marker/delta marker on the common pilot channel (code number 0 for spreading
factor 256; corresponds to displayed code numbers 0 and 1 of the x–axis).
Remote: CALC:MARK1:FUNC:CPIC
Remote: CALC:MARK1:Y?
Remote: CALC:DELT1:FUNC:CPIC
Remote: CALC:DELT1:Y?
PCCPCH
Sets the active marker/delta marker on the primary common control physical channel (code
number 1 for spreading factor 256; corresponds to displayed code numbers 2 and 3 of the x–
axis).
Remote: CALC:MARK1:FUNC:PCCP
Remote: CALC:MARK1:Y?
Remote: CALC:DELT1:FUNC:PCCP
Remote: CALC:DELT1:Y?
Min
For further details refer to the Min softkey in the marker–> menu of the base unit.
Next Min
For further details refer to the Next Min softkey in the marker–> menu of the base unit.
Next Min Mode < abs >
For further details refer to the Next Min Mode < abs > softkey in the marker–> menu of the base
unit.
Softkeys of the measurement menu (3G FDD BTS mode)
The following table shows all softkeys available in the measurement menu in 3G FDD BTS mode. It is
possible that your instrument configuration does not provide all softkeys. If a softkey is only available
with a special option, model or (measurement) mode, this information is delivered in the corresponding
softkey description.
Menu / Command Submenu / Command Submenu / Command Command
Auto Level&Code
Code Dom Channel Table
To Next Page
Loading...
