Changing Settings via Markers – MKR–> Key R&S FSL
1300.2519.12 4.72 E-11
Min
Sets the active marker/delta marker to the minimum of the selected trace.
If the Spectrogram Measurement option (K14) is activated, this softkey provides altered
functionality. For details refer to Min softkey in the marker–> menu of this option.
Remote: CALC:MARK:MIN
Remote: CALC:DELT:MIN
Next Min
Sets the active marker/delta marker to the next minimum of the selected trace according to the
mode selected using the Next Min Mode < abs > softkey.
If the Spectrogram Measurement option (K14) is activated, this softkey provides altered
functionality. For details refer to Next Min softkey in the marker–> menu of this option.
Remote: CALC:MARK:MIN:NEXT
Remote: CALC:DELT:MIN:NEXT
Next Min Mode < abs >
Selects the mode of the Next Min softkey. Three settings are available:
< Sets the active marker/delta marker to the next minimum left to the marker of the
selected trace.
abs Sets the active marker/delta marker to the next higher minimum of the selected
trace.
> Sets the active marker/delta marker to the next minimum right to the marker of the
selected trace.
If the Spectrogram Measurement option (K14) is activated, this softkey provides altered
functionality. For details refer to Next Min X Search < abs > and Next Min Y Search up/abs/dn
softkeys in the marker–> menu of this option.
Remote: CALC:MARK:MAX:LEFT
Remote: CALC:DELT:MAX:LEFT
Search Limits
Opens a submenu to set the limits for maximum or minimum search in the x and y direction.
Remote: CALC:MARK:X:SLIM ON
Left Limit
Opens an edit dialog box to enter a value for the lower limit (left vertical line: S1 for span > 0; T1
for zero span). The search is performed between the lines of the left and right limit (see also
Right Limit softkey).
Remote: CALC:MARK:X:SLIM:LEFT 1MHZ
To Next Page
Loading...
