Rohde & Schwarz R&S FSL3 - Page 1389

Remote Commands of the CDMA2000 BTS Analyzer Option (K82) R&S FSL
1300.2519.12 6.630 E-11
Channel results
Parameter Description
SRATe symbol rate in ksps
CHANnel channel number
SFACtor spreading factor of the channel
TOFFset
POFFset
timing offset in s;
phase offset in rad;
returns a '9' if the timing/phase offset
measurement is switched off (see
[SENSe<1|2>:]CDPower:TPMeas
command) or the number of active
channel exceeds 50.
CDPRelative channel power relative in dB
CDPabsolute channel power abs. in dBm (relative
to total or PICH power, refer to
CDP:PREF command)
EVMRms error vector magnitude rms in %
EVMPeak error vector mag. peak in %
Note: The result of the modulation type can be read out with the command
CALCulate<1|2>:MARKer<1...4>:FUNCtion:CDPower[:BTS]:RESult?
Power vs PCG
The number of returned value pairs corresponds to the Capture length
(see [SENSe<1|2>:]CDPower:IQLength command).
The results are output in the following order: <slot number>,<level value in dB>, <slot number>, <level
value in dB>, ...
Peak Code Domain Error
The number of returned value pairs corresponds to the Capture length
(see [SENSe<1|2>:]CDPower:IQLength command).
The results are output in the following order: <slot number>, <level value in dB>, ...
Composite EVM
The number of returned value pairs corresponds to the Capture length
(see [SENSe<1|2>:]CDPower:IQLength command).
The results are output in the following order: <slot number>, <value in %>, ...