Rohde & Schwarz R&S FSL3 - Page 1320

R&S FSL STATus Subsystem (Noise Figure, K30)
1300.2519.12 6.561 E-11
STATus:QUEStionable:FREQuency:PTRansition
This command determines what bits in the STATus:QUESionable:FREQuency Condition
register set the corresponding bit in the STATus:QUESionable:FREQuency Event register if that
bit has a positive transition (0 to 1). The variable <number> is the sum of the decimal values of
the bits that are to be enabled.
Parameter
0 to 65535
Example
STAT:QUES:FREQ:PTR 65535
All condition bits are summarized in the Event register if a positive transition occurs.
Characteristics
*RST value: –
SCPI: conform
Mode
NF
STATus:QUEStionable:LIMit<1|2> [:EVENt]?
For details refer to "STATus:QUEStionable:LIMit<1|2>[:EVENt]?" on page 6.245.
STATus:QUEStionable:LIMit<1|2>:CONDition?
For details refer to "STATus:QUEStionable:LIMit<1|2>:CONDition?" on page 6.246.
STATus:QUEStionable:LIMit<1|2>:ENABle
For details refer to "STATus:QUEStionable:LIMit<1|2>:ENABle" on page 6.246.
STATus:QUEStionable:LIMit<1|2>:NTRansition
This command determines what bits in the STATus:QUESionable:LIMit Condition register set
the corresponding bit in the STATus:QUESionable:LIMit Event register if that bit has a negative
transition (1 to 0). The variable <number> is the sum of the decimal values of the bits that are to
be enabled.
Parameter
0 to 65535
Example
STAT:QUES:NTR 65535
All condition bits are summarized in the Event register if a positive transition occurs.
Characteristics
*RST value: –
SCPI: device–specific
Mode
NF