Rohde & Schwarz R&S FSL3 - Page 1319

STATus Subsystem (Noise Figure, K30) R&S FSL
1300.2519.12 6.560 E-11
STATus:QUEStionable:CORRection:PTRansition
This command determines what bits in the STATus:QUESionable:CORRection Condition
register set the corresponding bit in the STATus:QUESionable:CORRection Event register if
that bit has a positive transition (0 to 1). The variable <number> is the sum of the decimal
values of the bits that are to be enabled.
Parameter
0 to 65535
Example
STAT:QUES:CORR:PTR 65535
All condition bits are summarized in the Event register if a positive transition occurs.
Characteristics
*RST value: –
SCPI: conform
Mode
NF
STATus:QUEStionable:FREQuency[:EVENt]?
For details refer to "STATus:QUEStionable:FREQuency[:EVENt]?" on page 6.244.
STATus:QUEStionable:FREQuency:CONDition?
For details refer to "STATus:QUEStionable:FREQuency:CONDition?" on page 6.244.
STATus:QUEStionable:FREQuency:ENABle
For details refer to "STATus:QUEStionable:FREQuency:ENABle" on page 6.244.
STATus:QUEStionable:FREQuency:NTRansition
This command determines what bits in the STATus:QUESionable:FREQuency Condition
register set the corresponding bit in the STATus:QUESionable:FREQuency Event register if that
bit has a negative transition (1 to 0). The variable <number> is the sum of the decimal values of
the bits that are to be enabled.
Parameter
0 to 65535
Example
STAT:QUES:FREQ:NTR 65535
All condition bits are summarized in the Event register if a positive transition occurs.
Characteristics
*RST value: –
SCPI: conform
Mode
NF