R&S FSL STATus Subsystem (Noise Figure, K30)
1300.2519.12 6.559 E-11
S
TATus:QUEStionable:CORRection:CONDition?
This command queries the contents of the CONDition section of the
STATus:QUEStionable:CORRection register. Readout does not delete the contents of the
CONDition section.
Example
STAT:QUES:CORR:COND?
Characteristics
*RST value: –
SCPI: conform
Mode
NF
STATus:QUEStionable:CORRection:ENABle
This command sets the bits of the ENABle section of the STATus:QUEStionable:CORRection
register. The ENABle register selectively enables the individual events of the associated EVENt
section for the summary bit.
Parameter
0 to 65535
Example
STAT:QUES:CORR:ENAB 65535
All events bits are represented in the CORRection summary bit.
Characteristics
*RST value: –
SCPI: conform
Mode
NF
STATus:QUEStionable:CORRection:NTRansition
This command determines what bits in the STATus:QUESionable:CORRection Condition
register set the corresponding bit in the STATus:QUESionable:CORRection Event register if
that bit has a negative transition (1 to 0). The variable <number> is the sum of the decimal
values of the bits that are to be enabled.
Parameter
0 to 65535
Example
STAT:QUES:CORR:NTR 65535
All condition bits are summarized in the Event register if a positive transition occurs.
Characteristics
*RST value: –
SCPI: conform
Mode
NF
To Next Page
Loading...
