R&S FSL SENSe Subsystem (EVDO, K84)
1300.2519.12 6.659 E-11
C
haracteristics
RST value: –40 dB
SCPI: device-specific
M
ode
EVDO
[SENSe<1|2>:]CDPower:IQLength
This command sets the capture length in multiples of the slot.
The numeric suffix at SENSe<1|2> is irrelevant for this command.
Parameter
2 to 12
Example
CDP:IQL 10
Sets the capture length to 10.
Characteristics
RST value: 3
SCPI: device-specific
Mode
EVDO
[SENSe<1|2>:]CDPower:LEVel:ADJust
This command adjusts the reference level of the R&S FSL to the measured channel power. This
ensures that the settings of the RF attenuation and the reference level are optimally adjusted to
the signal level without overloading the R&S FSL or limiting the dynamic response by a too low
signal–to–noise ratio.The numeric suffix at SENSe<1|2> is irrelevant for this command.
This command is an event and therefore has no *RST value and no query.
Example
CDP:LEV:ADJ
Adjusts the reference level to the measured channel power.
Characteristics
RST value: -
SCPI: device-specific
Mode
EVDO
[SENSe<1|2>:]CDPower:MAPPing
This command selects, when the mapping mode is not Complex, whether the I or Q branch
should be analyzed.
Parameter
I | Q
To Next Page
Loading...
