Rohde & Schwarz R&S FSL3 - Page 112

R&S FSL Cable TV Measurements (Option K20)
1300.2519.12 2.87 E-11
 K1
 L
 M
 N
 The Sound System parameter specifies how the audio will be transmitted. The possible values
depend on the TV Standard selected in the TV Standard list. The sound systems are named in the
form "sound carrier 1 / sound carrier 2'', e.g. "FM 6.5 / FM 6.258''. Information about the sound
modulation format and the carrier frequency with respect to the vision carrier is included.
Table 2–10: Possible values for the sound systems
TV Standard Sound System
FM 5.5 / NICAM 5.85
FM 5.5 / FM 5.742
B/G
FM 5.5 MONO
FM 6.5 / NICAM 5.85
FM 6.5 / FM 6.258
FM 6.5 / FM 6.742
D/K
K1
FM 6.5 MONO
FM 6.0 / NICAM 6.552 I
FM 6.0 MONO
AM 6.5 / NICAM 5.85 L
AM 6.5 MONO
FM 4.5 BTSC
FM 4.5 EIA–J
FM 4.5 / FM 4.724
M
N
FM 4.5 MONO
 What Group Delay shall the residual sideband filter have? The Group Delay setting has no effect
on the measurements in this firmware release.
 The Color System parameter specifies how color information will be transmitted. The possible
values depend on the TV Standard selected in the TV Standard list.
Table 2–11: Possible values for the Color Systems
TV Standard Color System
PAL B/G
D/K
SECAM
I
N
PAL
K1
L
SECAM
NTSC M
PAL
 Bar Line: The Vision Modulation measurement needs a special test signal, containing a peak white
value. You must specify the type and the number of the horizontal line that contains the peak white
value.