Rohde & Schwarz R&S FSL3 - Page 1143

SENSe Subsystem (Power Meter, K9) R&S FSL
1300.2519.12 6.384 E-11
[SENSe<1|2>:]PMETer:FREQuency
This command sets the frequency of the power sensor. The limits f
min
and f
max
are defined by the
power sensor.
The numeric suffixes <1|2> are irrelevant.
Parameter
f
m
in
... f
m
ax
Example
PMET:FREQ 1GHZ
Sets the frequency of the power sensor to 1 GHz.
Characteristics
*RST value: 50 MHz
SCPI: device–specific
Mode
PSM
[SENSe<1|2>:]PMETer:FREQuency:LINK
This command sets the frequency coupling of the power sensor.
The numeric suffixes <1|2> are irrelevant.
Parameter
CENTer couples the frequency to the center frequency of the analyzer
MARKer1 couples the frequency to the position of marker 1
OFF switches the frequency coupling off
Example
PMET:FREQ:LINK CENT
Couples the frequency to the center frequency of the analyzer
Characteristics
*RST value: CENT
SCPI: device–specific
Mode
PSM
[SENSe<1|2>:]PMETer:MTIMe
This command sets the measurement duration of the power sensor.
The numeric suffixes <1|2> are irrelevant.
Parameter
SHORt | NORMal | LONG
Example
PMET:MTIM SHOR
Sets a short measurement duration for measurements of stationary high power signals.