Rohde & Schwarz R&S FSL3 - Page 1352

R&S FSL TRACe Subsystem (WCDMA, K72)
1300.2519.12 6.593 E-11
TRACE1
5 values are transmitted for each channel:
<class>,<channel number>,<absolute level>,<relative level>,<timing offset>, ...
For the Code Dom Power Diagram result display, the channels are output in ascending order
sorted by code number, i.e. in the same sequence they are displayed on screen.
For the Code Dom Channel Table result display, the channels are sorted by code class, i.e. the
unassigned channels are transmitted last.
PWCDp
6 values are transmitted for each channel:
< class>,<channel number>,<absolute level>,<relative level>,<timing offset> or <I/Q–mapping>,
<pilot length>,...
CWCDp
10 values are transmitted for each channel:
<code class>,<channel number>,<absolute level>,<relative level>, <timing offset>, <pilot
length>, <active flag>, <channel type>, <modulation type>, <reserved>, ...
The channels are output in ascending order sorted by code number, i.e. in the same sequence
they are displayed on screen.
CTABle
7 values are transmitted for each channel:
< class>,<channel number>,<absolute level>,<relative level>,<timing offset>,<pilot length>,
<active|inactive>...
Parameter for RF measurements
TRACE1 | TRACE2 | TRACE3 | TRACE4 | LIST,<block> | <numeric_value>
TRACE1 to TRACE4 trace memory to be read out
LIST peak list data
<block> or <numeric_value> data to be transferred
(For further details refer to "TRACe<1|2>[:DATA]" on page 6.263.
TRACe1:DATA? LIST
This command queries the list evaluation results. All results are float values.
This command is only a query and therefore has no *RST value.
Returned values
<no>, <start>, <stop>, <rbw>, <freq>, <power abs>, <power rel>, <delta>, <limit check>,
<unused1>, <unused2>
Value Description
<no> range number
<start> start frequency
<stop> stop frequency
<rbw> resolution bandwidth of range
<freq> frequency of peak
<power abs> absolut power in dBm of peak
<power rel> relative power in dBc (related to the channel power) of peak
<delta> distance to the limit line in dB (positive indicates value above the limit, fail)